Contents of the guide Show ▾
Quick answer A motorhome fridge is either an absorption fridge or a compressor fridge. The absorption fridge runs on LPG, 230 V and 12 V. It is silent and can run for a long time on LPG without electricity, but on 12 V it draws so much current that it should only run while the engine is running. The compressor fridge runs on 12 V and draws much less current, about 0.35–0.56 kWh per day according to Thetford’s data. That makes it a good match for a battery and solar panels, but it needs a leisure battery that can cope with the consumption.
The choice between compressor and absorption is one of the most common questions when you build or buy a motorhome. This guide compares the technologies, goes through power consumption, running on LPG, ventilation and common faults, and is based on the manufacturers’ own user manuals and data sheets from Dometic and Thetford.
The essentials at a glance
- Absorption: LPG, 230 V and 12 V. Silent. Run on 12 V only while the engine is running.
- Compressor: 12 V with low consumption. Needs a leisure battery and charging, but no LPG.
- Absorption fridges need ventilation grilles in the outer wall and must stand almost level, with no more than about 3° tilt according to Dometic.
- Compressor fridges also need air around the cooling unit, but no flue outlet.
- Do the electrical sums before you choose. Use the electrical calculator.
Compressor or absorption: comparison
| Absorption fridge | Compressor fridge | |
|---|---|---|
| Energy sources | LPG, 230 V, 12 V | 12 V |
| Noise | Silent | The compressor is faintly audible, about 32–35 dB(A) according to Thetford |
| Power use on 12 V | High: for example 130 W for the Dometic RM 10.5 | Low: 0.35–0.56 kWh per day for the Thetford T2000 series |
| Without electricity | Can run for a long time on LPG | Needs a battery and charging |
| Tilt | Max about 3° when parked | See the manufacturer’s instructions |
| Installation | Ventilation grilles in the outer wall, LPG connection and flue outlet | 12 V cable, fuse and air circulation |
| Cooling in hot weather | Can suffer in high outdoor temperatures if ventilation is poor | Climate class SN-T (10–43 °C / 50–109 °F) for most T2000 models |
How an absorption fridge works
An absorption fridge has no moving parts. The cooling is driven by heat: an LPG flame or an electric element heats the cooling unit, and the refrigerant circulates by itself. That is why it is silent, and why the same fridge can run on LPG, 230 V or 12 V.
Automatic energy selection (AES)
Many Dometic fridges have AES, which chooses the energy source automatically in the order 230 V, 12 V and finally LPG. 12 V is only chosen while the engine is running. This is controlled by the D+ signal from the alternator. The electronics always need 12 V, even when the fridge runs on LPG or 230 V.
Why the absorption fridge should not run on 12 V when parked
Dometic writes that 12 V operation should only be used while the engine is running, otherwise the battery is quickly drained. According to its data sheet, a Dometic RM 10.5 draws 130 W on 12 V, which is about 11 A. On some older models the 12 V mode has no thermostat, so the fridge runs all the time. The installation should therefore cut the 12 V supply when the ignition is switched off, for example with a relay.
Running on LPG
On LPG an absorption fridge uses little. Dometic states less than 18.3 g/h (0.65 oz/h) for the RM 10.5. That means the fridge can run for a long time on one LPG cylinder without electricity. Dometic also writes that running on LPG while driving is only allowed if the vehicle manufacturer permits it, and that the fridge must never run on LPG at filling stations, in car parks or on ferries. Read more about the LPG system in the guide to LPG in a campervan.
How a compressor fridge works
A compressor fridge works like an ordinary fridge at home: a compressor pumps the refrigerant round. The difference is that it is built for 12 V. The compressor only runs when the thermostat calls for it, which is why consumption is low.
Thetford gives the following for the T2000 series (measured to IEC 62552):
| Model | Volume | Energy per day |
|---|---|---|
| T2095 | 90 l (3.2 cu ft) | 0.36 kWh |
| T2120 | 119 l (4.2 cu ft) | 0.45 kWh |
| T2138 | 138 l (4.9 cu ft) | 0.50 kWh |
| T2152 | 150 l (5.3 cu ft) | 0.47 kWh |
| T2160 | 158 l (5.6 cu ft) | 0.55 kWh |
| T2175 | 174 l (6.1 cu ft) | 0.56 kWh |
In Thetford’s product overview that corresponds to roughly 30–45 Ah per day at 12 V. Real consumption depends on the outdoor temperature, how often the door is opened and the ventilation. Thetford recommends 2 × 95 Ah of battery capacity, a 15 A fuse close to the power source and a cable size based on cable length: 2.5 mm² (12 AWG) up to 2.5 m (8 ft), 4 mm² (10 AWG) up to 4 m (13 ft) and 6 mm² (8 AWG) up to 6 m (20 ft). The fridge should be connected to the leisure battery, not the starter battery.
See cable sizes and fuses for 12 V and the guide to the campervan electrical system for how to size the battery and charging. With the right amount of solar, a compressor fridge can run without you needing power from the campsite.
Ventilation and installation
Absorption fridge
- Two ventilation grilles in the outer wall: a lower air inlet as close to the floor of the recess as possible, and an upper outlet above the fridge. For the RM 10.5, Dometic specifies at least 750 mm (29.5 in) between inlet and outlet.
- A floor opening is needed if the lower grille cannot sit level with the floor, so that any leaking LPG can flow out downwards.
- The gap to the wall behind the fridge should be small, 15–25 mm (0.6–1 in) for the RM 10.5, so that air is guided past the cooling unit.
- A draught-proof installation towards the living area, so that combustion air and flue gases do not get in.
- Stand level: while driving the tilt matters less, but when parked the vehicle should stand as level as possible.
Compressor fridge
- Air around the compressor and condenser according to the installation instructions. Cables must not block the air paths.
- A main switch so that 12 V can be cut completely during storage, plus low-voltage protection for the battery, according to Thetford.
- No LPG or flue gases to take into account.
Which fridge suits you?
- A compressor fridge suits you if you are building a campervan with a lithium battery and solar panels, do not want LPG in the vehicle, or often park off-grid without hook-up. See lithium or AGM for the choice of battery.
- An absorption fridge suits you if the vehicle already has LPG, you want a completely silent fridge, or your electrical system is small. It is also common in factory-built motorhomes, often together with an LPG heater such as a Truma Combi (in Swedish).
Common problems
| Problem | Common cause |
|---|---|
| The absorption fridge cools poorly in hot weather | Blocked or undersized ventilation grilles, or warm air collecting behind the fridge |
| The absorption fridge does not cool when the vehicle is parked | The vehicle is tilted too much, or the fridge is on 12 V without the engine running |
| The starter battery goes flat | The 12 V supply is not cut when the ignition is switched off, or the fridge is connected to the wrong battery |
| The LPG does not ignite | Empty or closed cylinder, closed tap or wrong pressure. Check the cylinder and taps. |
| The compressor fridge switches itself off | Voltage too low at the fridge, often because of a cable that is too thin or a weak battery. See why the motorhome battery keeps going flat. |
Warning An absorption fridge on LPG has an open flame and flue gases. The ventilation must be clear and the installation sealed against the living area. Have an LPG alarm and a carbon monoxide alarm in the living area. If you smell gas: turn off the LPG, ventilate, and do not use an open flame or operate switches.
Work it out yourself: the LPG calculator shows how long the LPG cylinder will last.
The fridge is part of the cooking and storage equipment, one of the points in the requirements for re-registering as a motorhome (Swedish rules).
Frequently asked questions
What is the difference between a compressor fridge and an absorption fridge?
An absorption fridge is driven by heat from LPG or electricity and is silent. A compressor fridge is driven by a 12 V compressor and draws much less current, but needs a battery and charging.
How much power does a compressor fridge use in a motorhome?
Thetford’s T2000 series uses 0.36–0.56 kWh per day depending on the model, roughly 30–45 Ah at 12 V.
Can the absorption fridge run on the battery when the vehicle is parked?
No. Dometic writes that 12 V should only be used while the engine is running, because otherwise the battery is drained quickly. When parked, use LPG or 230 V.
Can the fridge run on LPG while driving?
Only if the vehicle manufacturer allows LPG operation while driving, according to Dometic. It must never run on LPG at filling stations, in car parks or on ferries.
How level does the motorhome need to be?
An absorption fridge should not tilt more than about 3° according to Dometic. While driving it matters less.
Does a compressor fridge need ventilation?
Yes, air must be able to circulate around the compressor and condenser, but no flue outlet is needed because it does not run on LPG.
Sources and further reading
- Thetford, T2000 installation manual (PDF)
- Thetford, 12V refrigerators, product overview 2026 (PDF)
- Dometic, RM(S) 10.5 operating manual (PDF)
- Dometic, RM(S) 10.5 installation manual (PDF)
- Dometic, RM 4805 operating manual with AES (PDF)
- Dometic, RM 122/123 operating manual (PDF)
Last checked: October 2026. Always follow the manufacturer’s installation and operating instructions for your fridge.
New checklists and guides, plus reminders before winter storage and inspection. A few emails a year, nothing more.
The content is based on my own experience and the rules that applied when the text was written. Rules can change, and I am not responsible for factual errors or rule changes that affect your build or maintenance. Read the full disclaimer.

